Technical/Scientific Artefact 2 Assessment
- Subject Code :
ENG1100
QUESTION 1
On the ENG1100 title block, draw an orthographic projection of the geometry shown in Figure 1. This drawing must contain at least: the front view; the right side view; and a partial auxiliary view showing the true geometry of the inclined face as defined in Figure 1. Fully dimension the views and submit on the complete ENG1100 title block, including a complete title block. Use an appropriate scale and plot to PDF on an A3 sheet. If you have any questions about the geometry,
QUESTION 2
Produce an isometric view of the part presented in Figure 2 at an appropriate scale on the ENG1100 template
QUESTION 3
Produce an assembly drawing view of the part presented in Figure 3 at an appropriate scale on the ENG1100 template. The assembly views must include:
a top view of the complete assembly;
a half-sectional front view;
a complete parts list and part annotations.
QUESTION 4
Using the pipework isometric drawing in Figure 4,
list the number of welds of each type and size required;
create a list of cut lengths for each pipe (neglect weld size and spacing); and
determine the mass of each pipe spool. Approximate the mass of reducing fitting as the mass of an equal fitting of the largest branch connection size.
To communicate your working and answer, please submit length and mass information for each spool in a table using the format shown in Table 1.