Laboratory Work
- Country :
Australia
Writing up Step by step Cooling Curve Aim: The investigations' goal was to measure the rate of cooling in various substances and use the data obtained to create graphs depicting the cooling curve for each. Introduction: Calorime …
- Country :
Australia
Objective: To investigate the properties of an unconfined ceiling jet flow involving a pool fire. Apparatus: The apparatus consists of an unconfined ceiling jet flow apparatus with an adjustable floor allowing the height of the ceiling to be …
- Country :
Australia
Objective: To investigate a natural plume involving a pool fire. Apparatus: The apparatus consists of a thermocouple tree (See figure 1) with type K thermocouples at the spacing’s shown below. A Computerised data logging system is employe …
- Country :
Australia
Objective: To determine the effect of ventilation on fire severity. Apparatus: The apparatus consists of a test chamber with internal dimensions of 630mm wide, 580mm high and 600mm deep with a 550mm high adjustable door opening (See figure …
- Subject Code :
NUR2102
- Country :
Australia
Course Objectives measured CLO2 Apply theoretical knowledge and evidence-based practice to inform cultural safety, communication, planning, management, and evaluation of individuals experiencing acute illness and episodic health concerns or experi …
- Subject Code :
COMSOL
- Country :
Australia
Antenna Simulations Antennas are necessary components of any wireless communication system, enabling both the transmitting and receiving of EM carrier waves. This COMSOL simulation lab will investigate one of the most common antennas, the electri …